CVR Vacuum IR Finishing Line - CEFLA

The CVR finishing system works well for profiles & mouldings, and integrates sanding-coating-drying into one single & easy to use machine.

A vacuum unit applies water-based stain or primer uniformly onto any profile or shape to produce a consistent and uniform coloring. This vacuum process enhances grain definition without the need for brush or hand wiping.

• Made in the USA
• Pre-Sanding/Denibbing: Upon request the in-feed conveyor can accommodate sanding heads with abrasive strip brushes for pre-sanding prior to coating application.
• Vacuum Application: The stain/primer is applied by a stainless steel vacuum coater system. It is possible to control the amount of applied product equally on up to 4 sides by simply increasing or decreasing the vacuum level in the application head.
• Short Wave IR drying: After exiting the vacuum head the profile enters an IR curing tunnel and passes under multiple high intensity IR emitters. The emitters irradiate the moulding 360° for perfect curing in just seconds. The freshly coated mouldings can then be stacked or processed immediately thereafter.
• Combines sanding, staining and curing into a single, easy-to-use machine
• Sanding: fully-controllable pre-sanding with abrasive strip brushes
• Four-side, adjustable, vacuum application
• Multi-lamp, infra-red curing in just seconds
• Frequency-controlled feed and brush motors allow tightly controlled production speeds
• Integrated PLCs for full production control
• Low VOC emissions | Reduced flammability
• Closed loop system offers maximum transfer efficiency and minimizes coating waste 
• Low coatings costs
• Consistent results
• Small production footprint